Door Push Plate (16 Gauge)

Stainless Steel Door Push Plates: Push Plates - Finger Plates should be positioned with the grain of polish running vertically on the face of the door with the edge of the push plate 1 1/2 inches from the outer edge of the door. You should raise or lower the plate height as necessary, in order to center the plate from top to bottom at arm level approximately 42 inches from the floor.

Size Range: 3" to 8" Width, 7" to 16" Height. The Grain Direction of the #4 Polished Stainless Runs the Length of the Door Push Plates. 

Our SSTL Door Push Plates #4 Brushed Satin Polish matches US32D Door Hardware Finishes.

Since WE ARE the MANUFACTURER every little detail matters to us. Unlike Stainless Steel Door Push Plate "suppliers" "distributors" and "reseller Brokers" who drop ship to you "From the Manufacturer", WE ship it right from our own shop where we actually make your Kick Plates. With us there are no delays or waiting on third party Broker sellers to fit you on their multiple manufactures schedules. As the MANUFACTURER We have complete control from material procurement, quality control stops at every operation, packaging and shipping.

Our 16 ga. Stainless is .063 1/16" Thick, and is procured by us directly as Prime Coil Stock from the Mill in the USA.

Western Fabricating's line of Stainless Push Plates have a #4 Polished Brushed Finish that is super easily maintained and will keep its beautiful finish for many years. 16 gauge stainless T304 protects against scuffs, dents, abrasions and scratches, and is also corrosion resistant. We can also supply T316 Alloy Stainless for corrosive potential environments such as laboratories.

Stainless Steel Door Push Plates can be mounted by our Stainless Truss Head Screws, Counter Sunk Holes w Flat Head Stainless screws, factory applied 3M Permanent Two Sided Tape, or Magnetic Sheet factory applied on the back of the Stainless Steel which covers the entire back surface of the Kick Plate. Our special Factory Applied Magnetic backing covers the entire Door Push Plate stainless and can be mounted to and removed on steel doors. Our Push Plates can also be glued directly on your door (for that We Recommend LOCTITE PL MAX PREMIUM Adhesive). Tamper Resistant Screws are also available.

If you order your Door Push Plates with mounting holes the package(s) will contain the correct quantity of SSTL Screw fasteners required to mount. We also include a couple of extra screws just in case. Screw options are listed on each product page as either a Truss Head Philips Head or a Truss Head Security Screw and will be 3/16" Pre Drilled Clear Holes. For Counter Sunk Mount options we countersink the holes in each Protection Plate in our shop; and also include Stainless Steel Flat Head Screws that will mount flush in either a Flat Head Philips or a Flat Head Security Screw.

Every one of our Door Push Plates are fully Deburred for Smooth Edges. Other extra Options we provide include Rounded Corners and 45 degree Beveled Edges.

Our packaging and crating is engineered and built to arrive intact without product damage. Additionally all of our Material Ships with a Protective Vinyl that is removed after installation

*All of our mounting options are suitable for interior or exterior applications.